Dorman 533-904 Suspension Control Arm Bushing - Front Upper

Dorman 533-904 Suspension Control Arm Bushing

Dorman 533-904 is a standard replacement suspension control arm bushing for select Jeep applications. It is precision-engineered and tested to replace the original equipment bushing on the front upper suspension of the Jeep Commander and Jeep Grand Cherokee.

Key Features

• Direct replacement suspension control arm bushing for select vehicles
• Standard replacement grade for OE-style fit and function
• Rubber and steel construction for suspension mounting support
• Black finish
• Mounting hole diameter: 12.2 mm
• Dimensions include 60 mm length, 60 mm width, and 51 mm height
• Compatible with front upper suspension positions on select Jeep Commander and Jeep Grand Cherokee models

Detailed Description

This Dorman suspension control arm bushing is built for front upper suspension service on 2006-2010 Jeep Commander and 2005-2010 Jeep Grand Cherokee models. The Dorman 533-904 uses rubber and steel materials to restore the control arm’s mounting interface and maintain proper suspension location under load. As a standard replacement part, it follows OE-style dimensions and mounting specifications for the listed applications.

This part cross-references MOOG Chassis Products K200113 for the same application. It is a practical choice when replacing a worn Jeep Commander or Jeep Grand Cherokee front upper control arm bushing and when matching the original mounting style matters. The Dorman 533-904 is also referenced against Delphi TD1632W, Mevotech Original Grade GS25413, and Mevotech Supreme MS25413.

What It Is Used For

• Restoring worn or cracked front upper control arm bushings
• Reducing looseness in the suspension mounting point
• Addressing clunking or shifting caused by bushing wear
• Replacing a damaged OE-style rubber bushing on Jeep Commander and Jeep Grand Cherokee models
• Maintaining control arm alignment at the suspension pivot

Installation Notes and Tips

Install in the front upper control arm position only for the listed vehicles. Verify the mounting hole diameter, bushing dimensions, and control arm configuration before installation. Because mounting hardware is not included, reuse or source the required hardware separately if needed. Proper press-in installation and suspension inspection are recommended during service.

Quality Assurance

Dorman tests this suspension control arm bushing for fit and function as a replacement for the original equipment part on the specified Jeep applications. Part number 533-904 is built to standard replacement specifications for consistent service in the front upper suspension.